D130

ISO-2160
Detection of Copper Corrosion from Petroleum Products by Copper Strip Tarnish Test

A variety of hydrocarbon products including oils, hydraulic fluids, fuel, solvents, etc., can be tested for corrosivity to copper by use of this test. It is limited to products with Ried Vapor pressure no greater than 18 psi (124 kPa). A polished copper strip is immersed in the fluid and heated for a specified time and temperature after which the corrosion is rated by visual comparison to the ASTM Copper Strip Corrosion Standards. The most typical test run is for 24 hours @ 100°C. However, time and temperature can vary according to product type and specification. Results are reported as a number followed by a letter according to the following scheme:

1 Slight tarnish	A Light orange, almost the same as a freshly polished strip
	B Dark orange
2 Moderate tarnish	C Claret red
	B Lavender
	C Multi colored with lavender blue or silver, or both, overlaid on claret red
	D Silvery
	E Brassy or gold
3 Dark tarnish	A Magenta overcast on brassy strip
	B Multi colored with red and green showing (peacock), but no gray
4 Corrosion	A Transparent black, dark gray or brown with peacock green barley showing
	B Graphite or lusterless black
	C Glossy or jet black

(The ASTM Copper Strip Corrosion Standard is a color reproduction of strips which have the above description.)

Also see: D-130 D-4048 FMT-5309

REAL Services 700 Portage Trail Cuyahoga Falls, OH 44221.3057

voice: 330.630.3700 fax: 330.630.3733